DFW Mustang Forums banner
1 - 3 of 3 Posts

·
Krylon
Joined
·
873 Posts
Discussion Starter · #1 ·
Well guys, looks like I might haveta sell my baby. If not the whole car, than at least the motor out of her....

Here is the setup:
Kotzur Built 306
-Mexican Block .030"
-Custom Blower Cam
-Scat 4340 Steel Crank
-Scat 4340 Steel H-beams
-JE Dish Pistons
-Motor was assembled and picked up one month ago.

Longblock parts:
-Edelbrock Performer RPM Heads
-Edelbrock Performer RPM Intake
-Edelbrock 70mm Throttlebody and EGR Spacer
-MSD PRO Billet Distributor
-Taylor Pro Wires
-Canton 7qt Pan
-The $500 Comp Hydraulic Roller Conversion lifters (connected pairs)
-Summit SFI Balancer
-JW "The Wheel" SFI Flywheel

Vortech polished T trim with all necessary hardware.

Dynamic Mighty Mite C4 with Reverse Manual Valvebody, full competition specs including transbrake and a custom tq. convertor.

I'd probably try to sell the driveline before the car-what do ya'll think its worth?

Took a 3200lb car to a [email protected] letting off early on the 3rd pass down the track.

Should make around 700rwhp once its dyno tuned.

If someone with lots of money and not much time wants to go fast make me an offer!

LoL-seriously guys, humor me here-what is all this worth?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top