DFW Mustang Forums banner

1 - 8 of 8 Posts

·
FIRE!
Joined
·
2,028 Posts
Discussion Starter #1
Anyone install a water temp guage on a mod motor??? Where did you put the temp sensor at???
 

·
FIRE!
Joined
·
2,028 Posts
Discussion Starter #2
ttt
 

·
Premium Member
Joined
·
13,083 Posts
I put my sensor in the u shaped coolant rail on my car. your 2 valve doesnt have that but you may be able to use one of the spots where your stock temp gauge sending unit is. there are 2 sensors on the front of the motor one dr side one pass side (cant remember which is which) one is the sending unit for the ecu the other sends a signal to your stock temp gauge. if you used a T you could use both your stock gauge and your aftermarket one.
 

·
FIRE!
Joined
·
2,028 Posts
Discussion Starter #4
Thanks, for the info.
anyone whos done this on 2v feel free to throw in your 2cents
 

·
FIRE!
Joined
·
2,028 Posts
Discussion Starter #5
ttt
 

·
FIRE!
Joined
·
2,028 Posts
Discussion Starter #6
Come on surely someone's done this on a 2v!
 

·
FIRE!
Joined
·
2,028 Posts
Discussion Starter #7
ttt
 

·
FIRE!
Joined
·
2,028 Posts
Discussion Starter #8
ttt
 
1 - 8 of 8 Posts
Top