DFW Mustang Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
5,804 Posts
Discussion Starter · #2 ·
There is a tach port.. but I think that is where an optional tach adapter hooks up too??? or am i wrong.. the install sheet shows no wires to hook up to it... I guess I could give it a try anyways.. wont hurt anything (i hope?)
 
G

·
If there is a tach prong, just run the green wire of the tach (I believe it's the green wire) to that point. That's what it's for. Tach adapters are for Mod Motors without distributors.
 
G

·
The tach should have red/black/white/green wires. Green goes to the tach. Read the instructions. The tach wire, or signal, goes to the TACH port on the MSD.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top