DFW Mustang Forums banner
1 - 1 of 1 Posts

·
Cummins > Powerstroke
Joined
·
18,579 Posts
Discussion Starter · #1 ·
Well, Im about to start my swap on my 69. Im confident about doing the splicing the wiring into the existing harness and putting on the intake adn all that crap, but my questions are tuning it up to run nicely.

Im looking for any setup advice I can get. I know the throttle position sensor is supposed to be at < 1volt on the orange wire and the green should read 5 volts when running, but is there any tweaking to the mass air, or injectors or anything like that?

Thanks in advance.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top