DFW Mustang Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
322 Posts
Discussion Starter · #1 ·
I just put on a new MSD pro billet distributor on a week ago and it ran fine for a day or two. Now when I drive in low rpms (900-1600) the car will stumble and jump. When I get above that rpm range its fine but lacks some power. Do you think the timing can have been thrown off. I have it at 14* timing I will redo the timing to see if that is the problem. Could of anything else happened, please help.
 

·
Darkside
Joined
·
20,179 Posts
Not likely a timing problem. If you jumped a tooth on the drive gear it would run bad all the way through. You could always stab the original dist. to see for certain that is the problem.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top