DFW Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
803 Posts
Discussion Starter #1
Ok over thanksgiving i am changing the Rear main seal. and i was thinking that i might need to get my flywheel resurfaced while i was at it. I am NOT puting a new clutch in unless i find that i need one. the clutch that is in it is a king cobra with about 5,000 miles on it. Does the king cobra clutch use the same through-out bearing? Thanks. chris
 

·
heavy weight
Joined
·
267 Posts
ditto don't sufface it if your not going to change clutch.
did you resurface it when you put the new clutch in?
 

·
Narcissistic fade away
Joined
·
17,504 Posts
yeah.. it is a waste of time and money to surface a flywheel and NOT install a disc.. just change the seal..
 
1 - 6 of 6 Posts
Top