DFW Mustang Forums banner
1 - 5 of 5 Posts

· IA2
Joined
·
22,150 Posts
Discussion Starter · #1 ·
Goofy, goofy stuff - cmos errors, error beeps, no boot, "diskette failure" messages, etc. I'm pretty decent at diagnosing HW problems and this one I can't pin down.

It's a 233mhz P1 so I guess I can't complain LOL.....

Going to Fry's tomorrow it looks like.

<--laptop still works!
 

· Boost is Good
Joined
·
2,920 Posts
mikeb said:
Heh.... just found my old dusty "other" 233mhz P1 sitting around that I had forgotten about - parts transplant scheduled tomorr..... errr..... later today :)

<--cheap bastard
You Cheepo'. I got a Pentium 1 150mhz sittin around the house if you want to harvest any parts out of it?
 

· 98 SVT Cobra
Joined
·
5,088 Posts
I got a bunch of parts around here too Mike if you need anything.
 

· IA2
Joined
·
22,150 Posts
Discussion Starter · #5 ·
Hey, the rebuilt POS is working :D

<--dfwstangs.net = 1st internet test

The motherboard in the old Dell system went bad.

What's funny is that this P1 233 system was built from my original 386/33 case/powersupply with a motherboard swap so i'm now using some of my original PC again after 14 years woohoo!

Thanks for all the help offers, guys!

Mike
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top