I ordered my from either jegs or summit. Trickflow 7.65
best source for hardened pushrods?
Need to get a set of hardened pushrods for a 351 (hyrdaulic roller) I'm assembling.
Don't hit me over the head w/ the "use the pushrod length checker" club, I know I'll have to check... just looking for the best source for buying them once I figure out the length.
I expect it to come in somewhere btw 7.5 & 7.7... thinking it will take the 5/16 OD.
Correct me if you need to.
Whatcha got?
Don't hit me over the head w/ the "use the pushrod length checker" club, I know I'll have to check... just looking for the best source for buying them once I figure out the length.
I expect it to come in somewhere btw 7.5 & 7.7... thinking it will take the 5/16 OD.
Correct me if you need to.
Whatcha got?
1 - 5 of 5 Posts
Terry Manton, he did mine and had them in less than a week
For your setup, basic TFS or Comp Cam Magnum pushrods are fine.
Found them- thanks
1 - 5 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DFW Mustang Forums
A forum community dedicated to Dallas/Fort Worth area Mustang owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
