[360 Notch]

Ok, I decided Im gonna have to step it up and jump back into the game,

I hate my car so what better thing to do than to blow it up goin fast.

Decided to get out hte old sawzall and have at it with a ball peene hammer.
Gonna get out the cutoff wheel and finish it up (make it look ok) and then epoxy what I need wherever I need it.

heres some pics....and yes I know what Im doin.

 

[JMAC]

No!! Leave it alone!

 

[mk5.0]

I dont think you gain alot by shortening the runners on the 99 up intakes.
I think all they need is just some minor porting.

Now the 96-98 intakes need the short runners bad.
Look on the corral there is a million posts on it.

 

[Andrew]

Take it to HPP and have Manny finish it. They do badass work!

 

[360 Notch]

Take it to HPP and have Manny finish it. They do badass work!

now manny does badass work but why would I do that....

fellas Im more than capable.

thanks for the faith andrew.

 

[f0ur sixer]

[****** voice]You can do it![/****** voice]

 

[Andrew]

now manny does badass work but why would I do that....

fellas Im more than capable.

thanks for the faith andrew.

No offense meant... I have seen firsthand what Manny and those guys have built.
Good luck!

 

[HobieF3]

Ok, I decided Im gonna have to step it up and jump back into the game,

I hate my car so what better thing to do than to blow it up goin fast.

Decided to get out hte old sawzall and have at it with a ball peene hammer.
Gonna get out the cutoff wheel and finish it up (make it look ok) and then epoxy what I need wherever I need it.

heres some pics....and yes I know what Im doin.

I don't know what to say...

Either you are out of your fuckin' mind, or you are onto something BIG

 

[GRAYHORSE]

holy shit, your crazy man!

I got those 175lb 14" drag coilovers if you want them....

Greg

 

[doopie]

Ok, I decided Im gonna have to step it up and jump back into the game,

I hate my car so what better thing to do than to blow it up goin fast.

Decided to get out hte old sawzall and have at it with a ball peene hammer.
Gonna get out the cutoff wheel and finish it up (make it look ok) and then epoxy what I need wherever I need it.

heres some pics....and yes I know what Im doin.

Go For It...........

Take lots of pics and then post up the numbers.

 

[whiteboy]

BOOOOOM Bitch ..............................................for the 100th time

 

[momo stallion]

why is everyone worried? its not new or a secret.


but if you decide to quit, andrew is right, manny is the one to see on this.

 

[360 Notch]

any of you guys know where to get a crap load of industo weld (jb weld industrial strength)

all any one has is jb kwik which is crap...

 

[doopie]

any of you guys know where to get a crap load of industo weld (jb weld industrial strength)

all any one has is jb kwik which is crap...

Isnt JB weld plant east of dallas (20 or 30 not sure)You could prolly get something from there.

Doopie