How do you install an above the range microwave?

Frank · 01-04-2008, 09:02 PM

We are thinking of getting an over-the-range microwave oven. Currently there is one of those big vent hoods. I'd like to retain the ability to vent outside. How is this usually done? I was thinking I'd have to cut my hood and install the microwave, but I'm sure there are easier ways.

mikeb · 01-04-2008, 09:06 PM

I replaced our over the range microwave recently. There is a metal plate that bolts to the studs in the wall, and then the microwave mounts onto the metal plate. The microwave has bolt holes in the top that you run long bolts into thru cabinets or other supporting structures to pull the microwave up and into position. Finally, the microwave will have a vent on top that you can probably attach to your existing vent a hood duct using that thin metallic duct tape.

01-04-2008, 09:02 PM	#1
Frank The first, the original Join Date: Feb 2001 Location: Mesquite Posts: 6,556	How do you install an above the range microwave? We are thinking of getting an over-the-range microwave oven. Currently there is one of those big vent hoods. I'd like to retain the ability to vent outside. How is this usually done? I was thinking I'd have to cut my hood and install the microwave, but I'm sure there are easier ways. __________________ ...."I should already know the job was done properly as blood was drawn during the process, which I think is the creedo of the backyard mechanic. I have come to think of it as a small blood sacrifice to the Road Gods of Steel and Asphalt. Things just seem to work out better once a couple drops of the precious is mixed with oil while muttering a sincere oath in French."

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-04-2008, 09:06 PM	#2
mikeb IA2 Join Date: Mar 2001 Posts: 21,608	I replaced our over the range microwave recently. There is a metal plate that bolts to the studs in the wall, and then the microwave mounts onto the metal plate. The microwave has bolt holes in the top that you run long bolts into thru cabinets or other supporting structures to pull the microwave up and into position. Finally, the microwave will have a vent on top that you can probably attach to your existing vent a hood duct using that thin metallic duct tape.