slip on exhaust installation?

[Mikesyellow98GT]

one of my friends just installed a micron slip-on on his 06 ninja 636r... it eliminated a pulley system running from the pipe to underneath the seat( not really sure what its called or what it does)... there is a part that goes under the seat to replace it but the FI light comes on and doesnt go off... so is there a special way to install the exhaust?

[stunter bob]

hmm.....i always thought you had to have that pulley system on there...it controls a flap inside the stock exhaust to open and close at certain rpms to maxamize the power output....maybe you gotta reset the computer...un hook the battery for 15 minutes and maybe it will flash itself and allow that part to be hooked up and take it..i dunno
y dont you call the manufactuer of the pipe you bought..ask them what to do

[DRSVT]

read the instrutions they will tell u what u have to do for it to work correct

for example my 06 1000 i had to remove a wire from the comptuer for it to work the correct way just read the instructions and it should tell u

[big pappa pump]

most manu's have a piece that you install on the servo. you can buy them from m4 if you need one.