PDA

View Full Version : killed my clutch tonight

jrstang
09-07-2005, 09:51 PM
Went out for a peacful tuning ride,everything was going good then i decided to go full throttle on the entrance ramp and it held up to about 9k then she just let loose.Sure was fun making it home seemed she wanted to slip bad on anything past 4k after that. So anyways what brand clutches do you guys like the best im going kevlar just not sure what brand and no way im putting a stocker back in.
bucky
09-07-2005, 09:58 PM
I have only put one clutch in a bike i have owned and i used a Barnett.No probs with it and its an easy job.
DFWminis
09-08-2005, 12:28 AM
I have seen and heard alot of people using different kinds of clutches...and just about your normal rider seems to always go back to OEM clutch
jrstang
09-08-2005, 01:09 AM
anyone know where to get barnett clutches locally ?
ThreeFingerPete
09-08-2005, 01:27 AM
Don't put Barnett in there, it's junk.

OEM is good.
Whitey1039
09-08-2005, 01:51 AM
your a dumbass
ThreeFingerPete
09-08-2005, 01:53 AM
Ironic, ain't it.
Super Coupe
09-08-2005, 08:32 AM
I would just go OEM too.
Evile753
09-08-2005, 08:40 AM
OEM is the way to go......
grape
09-08-2005, 10:55 AM
what kind of bike is it? I might have some stuff laying around. Barnett might be crap, but OEM is sometimes more than $20 per friction plate on some engines.
jrstang
09-08-2005, 10:56 AM
what kind of bike is it? I might have some stuff laying around.
Its a 97 gsxr 750
grape
09-08-2005, 10:57 AM
I'll check tomorrow, i know i have a couple of cylinder heads for that generation, I'll check for lower end parts tomorrow.
jrstang
09-08-2005, 11:38 AM
I'll check tomorrow, i know i have a couple of cylinder heads for that generation, I'll check for lower end parts tomorrow.


Cool thanks,im going to pull it all out and make sure exactly what the deal is here in a little bit.
GARS04
09-08-2005, 12:14 PM
what kind of bike is it? I might have some stuff laying around. Barnett might be crap, but OEM is sometimes more than $20 per friction plate on some engines.

Your getting screwed buddy, I can get a brand new set of clutches for my ZX10 OEM for under 150 friction and metal. OEM is the way to go, I called Barnett a while back and they suck at customer service.