View Full Version : The Garage
- What rear end parts to buy?
- Porting and Polishing yourself...hard to do for novice?
- To E cam or not to E cam...that is the question
- Anyome knoa how to change Vortech pulleys?
- tach and shift light on 99 cobra???????????
- Car off, battery draining ..
- What duration and lift on a cam
- Tire Wear
- Anyone know if you can use 1.7s with the F303 cam?
- Is there a kit or something to put a 5.0 in a 99' Ranger?
- fuel pump
- My car is slower when I had Upper/Lower Cobra intake installed on 94 GT
- car is pinging need help!!!!!!!
- Hypertech Power Programmer III
- Timing question, again!!
- Cam, Gears, and Headers
- AIR BAG Light Flashing......
- ABS light flashing
- Weight Reduction
- Need Feedback!!
- Cam For Street --
- Steeda Double Hook Clutch Quadrant install help!
- COPPER HEADGASKETS
- Good Deal?
- Starter question??
- Head Question
- Alternators
- Anyone with a 2001 Automatic GT with aftermaket gears
- EEC-IV question...
- E-cam
- Auto Trans Choices
- Anyone removed the smog stuff on a 94 GT?
- Best Ignition?
- tachs and shiftlights on 99+ (theory inside)
- Could it be the driveshaft?
- drive shaft rubbing up against brake line
- Starter grinding on flexplate???
- Port and Polish
- fuel problem???? help???
- Need Help Choosing an AOD!!!
- My doubts on 4:10's
- Pics of Engine
- Trashing belts w/D-1 Why???
- Mini starter question
- found my problem sorta: starter
- Anyone know what could cause this to happen?
- aftermarket ignition
- Get the heads loc-wired or not??
- Best type of exhaust gasket and bolts?
- f150 steering adjustment
- T-Rex Needed?
- what is the eisiest way to install a a/f ratio gage on a 2000 gt
- What fuel PSI can I run with 30lbs injectors?
- Electrical Problem
- Got Some Money...Help Me Spend It.
- Gears
- AOD to T-5 Swap?
- throttle body and egr
- Damn car is getting hot>>
- Injectors not coming on
- Anyone use electric fans in here?
- Another car getting hot....Need help!
- Equal or Uequal headers???
- will my car sound pretty good with mac hpipe and stock mufflers on a 2000 gt
- Question for the turbo junkies
- Running Hot
- Carparts.com 20% off coupon....
- front/rear seal's??????
- Magnaflow Exhaust and Tires
- can anyone help me put my springs and h pipe on please
- rear end fluid
- Pulling codes
- ECU reads o2 sensors....
- can i run my a/f ratio gage to o2 sensor on h pipe
- X pipe vs. H pipe
- spring sizes
- Missing above 4500
- How do you change the front springs on a fox body?
- Cam question...
- Low Volts...HELP!
- 5.4 F150 Motor
- wheel and slick question
- 94-95 Electric Fan
- Help with FRPP 1.6 Roller Rockers
- fuel pressure
- No Oil Pressure at lights???
- NOS??????
- Question need help!!
- o2 sensors
- Steeda Timing Adjuster
- Widest tire on 15x8 wheel?
- Anybody had problems w/ MIL Eliminators?
- Anybody know the Flow numbers of Stock 2000GT heads.....
- Good port and polish???
- Factory tach wire................
- B-Cam or E-cam?????
- Changin heads how hard ?
- stock heads
- Cobra tranny swap???
- which out of the 3 wires on the o2 sensor do i hook the a/f ratio gage wire up to
- Cam swaps...
- Fuel pressure regulators
- Anyone ever do the Pep Boys 3 core radiator swap..?
- 351 Windsor Heads
- E or F- cam
- need lots of help and or advice
- Which Springs??
- AOD to T5 swap, how tough?
- vacuum issue
- Question?
- anyone know how to........
- Starter Question
- Re-setting ECU on my LX
- Fuel Problems
- Injector Modifications??
- Question on dyno's
- Overheating...
- Sticky tire for 16" wheel...non daily driver..?
- HIGH PERFORMACE WORK IN HERE
- My 347 runs HOTTTT!
- what different - mexican block
- AL P and all of the rest of the pushrod lovers, help me out
- Hmmm TFI???? Opinions...
- NE1 know of a supplier for quality silicone hose?
- IVE GOTTA PROBLEM
- 460 Swap
- anyone installed abbott era themself?
- Cooling issues on DSS 306
- 302 W/ Windsor Heads
- anyone had experience with a good junkyard turbo setup for a 5.0?
- I need help with my damn TREMEC!!
- I need advice...
- Anyone here running 4.56's with an AOD or AODE?
- Anyone have Advance Curve for S/C 4.6 GT...
- What do you think I sould do next.
- What do you think I sould do next.
- MSD 8975 install...help me with the retard wires
- mafs question
- rpm questions on gears?
- Boosted People...Air Temps?
- Pump gas and boost...
- rough idle, what causes it?
- R.A.C.E. Systems Powerflex Hose?
- 4.6 question.........
- Poll: is this a blown head gasket?
- Belt Question!
- Temp. question
- Somebody please help me!!!!!
- who likes performer 5.0 intake
- ne1 with 26/11.5 et streets
- HELP..S-trim on a 302....PROBLEMS!
- Autozone's Performance Friction Brake Pads
- Wrapping Fuel Lines?
- The Devils Lawsuit
- 95 gt aode how much hp will stock ones hold? how much to build ?how much slower?
- Mine Runs Hot Too
- Guage help
- Widest rim on a Fox Body
- What color wire for tach???
- Are 5.0 H.O. valve covers taller than non-H.O. valve covers?
- What is this?
- Questions about Pro M meters
- rearend question
- 4:10's or 3:73's
- Upgrade opinions???
- Engine Power Estimates and questions:
- Does anyone own an 85?
- Runs Hot Please help
- Spark plug reading...yellowish...
- Dam starter?
- Do I have blown head gaskets too?
- round two with the S-trim problems....please help?
- Nitrous (so-called) experts...
- Water out the tail pipe?
- Torque Box Problems
- Cobra 13" brakes...........
- What color should the plugs be after 6 hard NOS runs?
- Motor Up
- Any diff. between these 2 gaskets?
- GT-40 p heads
- WTF: Vibration or something
- If I get a pwerdyne for my 98 GT ??
- OBDII (2) ???
- Top Gun Kit..........
- n/a genuises please come forward
- I need combo help
- Demon or Holley Carbs
- PVC connection...???
- Paging Andrew - call me!
- Is it ok if...........................
- Box intake...opinions, polls...
- What is the PROs and CONs of a...
- Need Local Opinion !!!
- rotated mas air sensor
- How much HP can 42lb ford injectors support
- "ABS" Lite On. Why?
- 69'351 w in 94gt help has anyone done this that i can talk to?
- Blower with Carbs?
- Round 3 S-trim, belt slippage or BOV problems?
- Do you need special headers for the Canfield head?
- Which chip is the best?????
- Evans coolant?
- Help again on cooling?
- Water pump
- MSD question. Can you use the adj timing control on a Stang?
- I need help I have this in the main forum also
- BEST GAPPING FOR SPARK PLUGS
- Fuel system question
- 4.6 Cobra motor ticking noise???? Help!
- Does 10MPG on 19#'s @ 46-48PSI sound right?
- Allrighty, who runs 30lbs injectors on a 302-306 block with all mods?
- help programming computer
- Mods....Where to start with a 99 Cobra?
- Need to borrow 19# sample tube
- Another Overheating Prob.
- EEC-Tuner
- Color of C&L 30# sample tube
- Will GN injectors work on a Stang?
- Whos at a dealership to help a bro out with a warranty 99 cobra
- eec tuner for 2000 GT
- Degree wheel
- Is a Spider Intake too Much for a 331?
- Optimum Compression for a 347 Stroker @ 17#s of boost?
- Radiator helllllp!
- Mods....Where to start with a 99 Cobra? -=Continued=-
- Attn: Jose, bard, and anyone else who can help
- Teflon or no teflon...
- Am I in Dream Land?
- Edelbrock Performers vs TFS Twisted Wedge
- Need opinions again
- Exhaust help
- Pacesetter o/r h pipe OR BBK o/r
- SURGING IDLE
- GT-40 head install
- Need a good source for 12V switched signal
- another overheater.....
- Big Question
- Best way to get away with 10.0:1 compression and boost?
- How much is a 55 gallon drum of race gas?
- Just out of curiosity...will a NA 4 convert to a Turbo 4?
- Anyone running TFS Track Heat on blower car
- Very strange problem with stang
- Which plugs and what gap for N2O with X heads?
- Where is my fuel fitler located?
- 6500rpm, glide, 4000-4500 stall, 28" tires, and lets say 900 rwhp ...what gears?
- Ques. are Holley Injectors any good.
- What is the difference between....
- Question about lowering springs...
- it seemed like it ran out of gas!? but no spark?
- help me please!!
vBulletin® v3.8.1, Copyright ©2000-2009, Jelsoft Enterprises Ltd.