- building up a 351w
- Kwik Kar Campbell/Jupiter Owner is a Dick!!!
- Cold Start Problem
- Leaking radiator, headgasket faulty?
- I have a few questions....
- Cost on Supercharger
- Carb tuners..........I need some help
- Dang! i think i might have got the wrong pistons
- Need torque boxes welded
- flywheel tooth count
- curious about track times
- tig or mig
- Holy SH*T
- who knows of a good mech. shop that will bore a block and turn a crank???
- How to tell
- roommates ss making a clicking sound under the car
- help on some rims and trim
- Rearend is narrowed!
- help .......injectors
- dunzo
- Cleaning MAF
- Need some help guys.
- Powertrax Locker
- need help w/ wire for F.A.S.T to MSD
- 99 COBRA 5 SPEED what trans is this
- Ok! are these the right ones i need!
- autologic chip reburn
- IAT sensor
- What is wrong with my car....
- interior paint
- widest tire for a 17x9?
- need paint code
- Superchips programmer Question
- Recently built 306...
- Wetsanding woes..
- Intake Question?
- Ceramic coating.
- what brand of gears?
- Experienced C4 peeps get in here..
- 1/4 times
- everyday car advice?
- The web's largest 5.0 FOX BODY GALLERY - Update
- mahle pistons, any feedback?
- The TA in the Speedtek banner....
- Snow Performance Boost Cooler
- my radio is buggin'....
- Cam question
- header bolt lenght and diameter.
- Rear firewall for hatch question
- ?Will moser 31 spline axles from a 01 gt work for the mach rear
- nos question
- Radio Problems
- Nitrous gurus needed.
- Stubborn transmission leak - T-5
- Powerglide or Built C4
- Anybody do a carb to EFI conversion?
- A/C bracket
- A/C recharge
- NE1 know the thread size of the 5.0 oil level sensor
- motor&trans swap need info
- Breaking in new motor on 1,100 mile drive
- who builds custom exhausts??
- What tires
- Typical stock A/F of a 89-93 5.0?
- Headers make you run lean?
- What do ya think? first mod?
- What tooth speedo gear?
- will a speedcal work on a 94
- problem with adj fuel regulator
- Gutting cats.
- removing brake lines...
- Timing advance with AFR heads
- steeda cam question
- when is it time to upgrade the fuel system?
- p/v clearance ??
- Need Advice On Motor
- help
- How much would you paid for…
- Does anyone know how to hook up a Hurst line lock?
- Fox body safety issue!
- stock rwhp of 01 gt?
- Battery Relocating Question?
- Who's the wiring Masta!?
- What is a G351 Block?
- Anyone around here have a running Z31...??
- Trac Loc
- Flasher Relay?
- Will Intake Fit?
- where to find carpet?
- 315's on a 99 gt spacer required?
- N2O nozzle placement
- Fixing Rust?
- turbo/auto/transbrake owners...question
- Irs Question
- Honest Opinion needed
- Pulley Installer Tool Usage
- problem with tach on 86 stang
- 4.6 blower ???'s
- torque converter problem... I think?
- New motors DONE, dyno #s inside!
- Relocating the ACT...
- t5 rebuild question
- What is a good rebuild kit for a stock trans
- is s/d makein my car run rough??
- update on summit racing customer service
- will my rims fit on an 03?
- 393 pistons
- Junkyards! in DFW area.. NEED ASAP!
- Anyone heard of "Moto Tron" injectors?
- Fuel pressure question.........
- Where to buy 17" Nitto drag radials?
- Finally got the UCA/LCA done.
- what kind of heads are these
- Fuel Light
- Is This Good Compression
- axle upgrade?
- My alignment is still off... help please.. *pics*
- What does.....???
- E0AE Block
- How long to do a 5 lug conversion?
- Non-Roller Block to Roller Block
- Local Custom Headers
- once again another summit update
- Is this too much?
- so I was driving down the street.....
- What do yall think I can get for my car??
- Cheap Towing Service
- Where to get airbags???
- Carb gurus:
- Belt Length question for 87-93
- Is an aluminum drive shaft worth it?
- need some help... who has receipts
- throttle or electrical problem...
- convertor question
- Has anyone had this problem?
- Rust stains
- explorer axles in a mustang housing????
- a/c delete ?
- what a/f to run at under boost and all....
- LT-1 gurus, in here please.
- Anderson FMS cam= emissions friendly?
- bad89stang hiding wires
- $10 alignments!!
- carbed regulater help
- need help engine making noises
- Q's about a 160* thermo...
- lowered 99+ with 18s???
- Anyone wanna make $$$$$
- does anyone have slp loud mouth exhuast
- Those crappy sun visors
- Will 28x12.5 ET Streets Fit a Coupe?
- MSD Coil OR Crane Coil
- Anyone know a DFW shop that would rent out their spray booth for a day?
- where can i buy fox seat belts?
- VRS X pipe
- Speed freaks!
- What is this car worth?
- offering up my services for AC recharge/repair
- BMR Fabrication
- Ground Cable
- Roller block basic training
- Eec Iv
- Good tint shops in Ft Worth?
- Hmm... i dont know what it is..
- how easy is it?
- Alcohol ?
- Balancer won't come off!
- can u run an accell super coil w/msd6al?
- tinting
- AC Service
- here is a blower warrently question for you guys....
- 3550 Tremec
- S trim pulley size
- Where to buy a Chromemoly Roll Cage?
- Anyone have helpful knowledge about the powerstroke?
- Overhaul Kits ???
- Custom Chip
- Started my Turbo Install
- would like to know
- Shops in Houston???
- Upholstery companies in DFW
- ignition coil question ?
- creating a build sheet
- anyone know where to pick up a rear clip for 99 up , need good body man
- New blower belt for 01 Lightning...
- so why do i hear everyone say................
- Fox Body Vert Motor Mounts
- The Last of the Cobra 302s...
- Headlight Question
- clunking noise from the rear?
- battery terminals keep contaminating.... causes/solutions?
- Question can I turn my 4lug moser axles into 5lug pattern....
- Headlight cleaning kits
- Who has a 351w with a procharger on a fox body
- Question: Bassani x-pipe fittings
- Cobra 1.7 rr ?
- IAC? 99 gt idle probs...
- T-5 or C-4 ?
- 331 rods and pistons?
- Throttle Body question
- man.. i almost started my coupe today.
- How hard 2 put in/buy new motor/tranny
- Question on getting a dash assym.
- Any good auto tranny builders?
- Mustang EFI computer question....
- I have a Tach problem
- pulleys
- T-5 is toast, do you think anything else is hurt
- Engine Masters Challenge
- Stock water pump pulley?
- Mod Stroker Is Alive
- Machine shop that will turn axles???
- Tranny repair shop
- main bolts
- main bolts
- Turbo guys in here
- injector questions
- To Blanace or Not To Balance
- is it rumor that no front license plate..
- exhaust work...
- Fox Body Fuel System Upgrade?
- Dist. stuck???????
- anyone run 4.88s
- motor differences
- how to set-up switch ignition---bootleg style
- damn map light!!
- Ford newbie here
- Cam spec...
- someone know of a machine shop that will.....
- It Started!! Rough, but running!!!
- I took my '95 GT for a spin, and...
- Damn Flowmasters!!!
- Valve cover clearance question
- Starting issues
- Tire wear issues....HELP!
- fuel filter question
- Next Mod?
- automatic flywheel balance
- what is the stock hp on a
- Anyone Looking For 79-93 Fiberglass Fenders?
- D-1 Procharger?????
- May need some head work done.
- Something's outta whack...
- Anyone actually dyno'd HP/TQ gains from Underdrive Pulleys?
- where can you get cloth dye?
- How to pull out broken valve cover stud???
- radiator flush/fill
- car leans....
- Brake Caliper Rebuild kit
- tire size