View Full Version : The Garage
- Electrical Help for Lincoln Mark VIII
- where can I get o2 bungs?
- Rough idle, car dies
- the best place for car repairs
- Don't laugh but what's an IAC valve?
- sweet new programmer/reflasher.......
- Necessary vaccuum lines?
- car justs turns off please help
- 4.6 timing
- 03 seats in a 89lx??Help!!!!
- fill me in on Gen6 DFI
- bumper cover question.
- Corbeau Seats locally?
- Still Too Much Boost!
- 91 2.3 LX Pictures?
- need help on head gasket choice
- sparkplug suggestions?
- Cervini or Harwood?
- cam q's
- Where is the 94 GT fog light switch?
- Chip or Programmer
- What is NOS's website?
- my bearings screwed????
- efi harness
- tranny conversion
- driveshaft shops in the area?
- Help! what t-5 pilot bearing?
- Can I flush the motor with diesel?
- Light Mist From Oil Breather
- got some questions
- Tommie Vaughn Motorsports
- need a mechanic around ft worth!
- Where to buy upper control arm bushings?
- What should I get? MAC Prochamber, X-Pipe or H-Pipe???
- 4.6 surging at idle?
- Info on new engines? <---
- Dyno Tune
- Overheating problems
- starter Issues ??? Help !!!
- Quick Question?
- anybody have magnaflow and O/r x setup?
- air bag
- fog light wiring
- Can't Get Off P/S Hose
- anyone running a mech fuel pump?
- engine problems
- Can anyone confirm this???
- where to get speedo gears?
- torque boxes and subframes
- What Else Do I Need???
- Question about setting hyd lifters....
- cam info/advice
- diagnostic codes... OBD II
- headlight adjustments on a sn95
- backfiring saga continues...
- Vortech Pulley
- edelbrock heads??
- Help with Cruise and Horn
- Tires Size ?
- 99-up IRS max power?
- where to get o2 sensors for 96 cobra?
- 5.0 to 5.8 swap for 93 GT Convert. info.
- Best catback for 96 cobra?
- need some help
- tire question for 88 mustang gt
- shortblock assembled.
- What's that in my AOD pan?
- Which x-pipe is better for hp/torque?
- rear window drivers side
- Mod Motor Guage Question? Help!!
- Somebody School Me On Long Rod 302 Basics
- Proform
- Plug part number?
- Gt-40
- motor mounts
- heater tubes?
- What are the maximum specs on a smog legal cam?
- Fuel system diagrams for injection.
- Fuel Pressure????
- Car jerks.......
- Donuts for skinnies?
- computer ?
- Which chip to use?
- What is going on w/ my 99GT?
- Homemade Elec Fan wiring kit?
- where to get wheels chromed ?
- Fuel rail guage question.
- where's a GOOD place to get a driveshaft re-balanced?
- Yoka. EVS 100's, what do you think?
- can anyone I.D. this injector?
- for those running a short belt
- gauge opinions
- airline workers, some AN fittings please?
- timing is jumping?
- 351 question
- Picking a cam
- Is $110 a good price for Diablo chip reburn?
- Driveshaft Balancing Shop
- Cheapest place to get NEW FMS 42# injectors?
- Mechanical fuel gauge
- Fuel Pressure Question and problem
- T56 and IRS on a 94 Cobra?
- no oil psi
- Transmission for a 66 Ford Pickup
- Mod friendly dealers
- ROAD TRIP! Need help tuning for better gas mileage.
- Installing windows
- how do you remove...?
- Why is my sh*t pinging?
- How much HP
- car is acting funny....not enought fuel?? not sure??
- Pi heads?
- What are these trouble codes on a 96 cobra?
- Valves for Edelbrock heads
- Been driving the car a little and...(and thanks to forrest)
- Shift light for 4.6
- Got a question about starting the car
- New Dyno Numbers!
- Damn valve cover leak
- 4.6's with canton pans in here please!!
- 97 and 01 GT Motor Questions
- mach 1
- engine problems
- Timing and Tuning. (spelling lesson)
- how much......
- Turbo 2.3 carbureted
- a/c trouble
- "p" headers????
- ** any way to adjust shifter stops>**
- 11.50's @114mph, is that slow for mph?
- What are the pros and cons to an automatic versus a five speed?
- What size and thread pitch for motor mount nut?
- what size are the bell housing bolts
- Bolt size list... Pretty handy
- trick flow r vs holley
- Headlight lense cleaning.
- New guy needs Heads-up on heads
- idle adjust screw, 99
- advise
- sn95 axle ?
- Turbo Help??
- 2800-3200 stall or 5 speed?
- Valve stems for Weld wheels?
- Are 98 pedals the same for 94-95?
- Need a local Machine Shop
- Ignition question
- adjusting idle
- Ummm...i need new mufflers...which would you prefer?
- Anyone here have an AC leak detector???
- Warlock mufflers?
- just for info...running magnaflow catback and bassani x pipe
- adjusting roller rockers??
- 5-speed conversion wiring?
- need help tonight!! garland people please look.
- What HAS to be changed out
- Blown Head Gasket???
- ?hp and tracktimes
- girdle w/o getting align honed?????
- 97 Cobra what Gears?
- Auto to Stick?
- 460 swap into 89 stang?
- Is it tough to put a front/rear bumper cover from a '87-'93 on a '83-'85 car?
- fuel injected swap into an 85 carb car
- Ok, what setup???
- 96-98 GT, cobra exhaust
- anyone have an extra....
- intake?
- All 96-98's with 99+ 2v swap come in please. Long
- Hey I found a pretty cool tuning forum....
- Carb spacer?
- Wes Or Stroked>>>>>
- Vecco twin tubo kit?
- Charging problem
- Just to get clarification, PI head rehash....
- What intank pump for blower setup?
- Headlight trim question
- is this cam timed right? forrest?
- Rim got bent :(
- Best place for fiberglass fenders for Fox cars?
- MRT Billiard Sized Shift Knob
- Super Coupe Ranger
- good machine shop to have distributor gear installed?
- Mobile Windshield repair?
- 98 Cobra Headers?
- Well.....got the car weighed....
- Anybody have one PS stock motor mount?
- I need New Heads...Suggest Some Heads Please
- Exhaust...how big is too big?
- what intake?
- Has anyone actually weighed thier car...
- well tore into the shortblock I bought
- Race gas where do I get it today-Friday? (North East side of Dallas)
- White Smoke On Startup
- A little Help!
- Camshaft repair?
- Price for 5.0 motor?
- rear spring ?
- I need to get my inspection done
- Convertible top replacement
- Best Place in DFW for Gear Install
- water pump rotation
- Whats Wrong !
- Rebuilding Rearend
- anyone want to help pull my motor out tommorow.
- ~~!!AFR 185 Owners ,Please HELP me!!~~
- how much power with carb?
- '99 - '03 IRS into a Fox swap
- Trick Flow???
- Anyone Running Tfs Street Heat Intake
- where to buy smoked headlights?
- paint
- Trick Flow Cam in 93 Cobra Question
- Several thousand $ and .6 sec slower?!?!
- 93 Cobra Engine ? And Ds ?
- 10 in 5lug problem
- what wheel size?
- New Brakes
- Anyone who has assembled a 4.6, in here please!!!!
- WT SPRAY 2003 V-6 chevy truck...
- Help Please
- Question about installing cats
- What's this?
- Any suggestions on a chip?
- trouble shooting on a 96 cobra
- Gear related question
- Couple questions (fuel pressure, and MSD related)
- intake price?
- 2.02 Intake's on a 302
- TF Twisted Wedge Help
- How to pick valve springs??
- 750dp ?'s
- 5 lug conversion on 4cyl. LX
- s/c for '02 GT????
- Fuel pump for n2o?
- spider intake
- Transmission Question
- Tranny probs.
- 2.3 Head Torque Specs?
- Timing???
- 99-03 mustange 4.6 2v questions
- header gasket?
- Trick Flow vs AFRs and Performer
- The new "LXLAW" Yea Baby!!
- ProCharger questions
- 4.6 2v dumb question - serious reply's needed.
- 305 TBI upgrades???
- where's the mustang shop?
- Aeromotive FPR (Vacuum line)?
- Question on TPS setting
- What gauge of wire...
vBulletin® v3.8.1, Copyright ©2000-2009, Jelsoft Enterprises Ltd.