- Summit Discount Code??
- what's a good brand for an FPR?
- harmonic balancer....
- RPM problem....help
- I need some help........
- Can anyone install some springs on my car for me?
- Muffler shops?
- Back firing???
- starter selenoid problem
- ? about a carb spacer
- nitrous kit wiring help
- Wiring Harness
- My car passed the Emissions Sniffer!!
- ran a compression test, atleast the best I could
- Will a superchip for an 00' GT fit my 87'?
- Opinions: For my 1966 Fastback GT
- 306?
- Where can you get one of these???
- `Is it normal......???
- distributor question
- Don't have shop air?
- Need help ASAP
- Tb?
- Gear oil for 8.8?
- Is red interior really that bad?
- Wlid Boar"outlaw" converters ?
- Old school Pontiac gurus, check these out.....
- Need emissions equipment and vacuum line help..forrest, anyone!
- **chip question**
- Fuel pressure problem again???
- fittings for Kirban FPR???
- b&m console shifters for AOD
- Recommendations on a shop
- what to torque rockers to
- Will 94gt heads bolt right on to my 86gt?
- removing tint glue
- How do you think?
- Mild BOOM B*tch.
- Custom Timing Curve
- BBK Longtubes
- So my girl wakes me up..........
- intake for a 331 turbo?
- Bogged down at WOT?! 93 coupe
- Best Spark Plugs on '03
- 200r4 into a mustang?
- Where to get custom chip locally...?
- Best place to install nos nozzle
- a stock GT
- Differences in 3550 and TKO for modular?
- Power Pipe or Throttle Body
- Remote Start
- v-10 mustang
- Where can i get an import a/c compressor?
- AFR Head ?'s
- Another Cobra Master Cylinder question
- Flywheel sound?
- need advice on best repair of cracked out lower intake bolt hole
- anyone here have desktop dyno?
- nitrous on a 200,000 mile motor?
- Need a Supercharger know it all
- Yet another chevy ? (Rings)
- What is everyone's experience and opinions on Harland Sharp Rocker Arms?
- Anyone have a trailor....
- Pulley Puller in DFW?
- Where to get a removable steering wheel
- Passing Emmissions...Facts or Myths
- one of those friggin' days... (carbs rule?)
- Idea
- Would 28" slicks kill my motor times?
- Are windsor sr's to big for my combo?
- AC parts
- "The Shakes" From Speed Withdrawal?
- Does anyone sell a rear delete kit
- Performance repair Shop?
- thanx to mean98 and saladbar
- parts place or good junkyard?
- Please Help!
- coverting 6cyl vs 4 cyl fox bodies
- 82 bronco 9"
- Nitrous OXide
- Panhard bar?????
- my 28.00 carpet job
- Forged 302 tfs?? 331or 347 stroker???
- Motor Help
- Need A Nice Cage For Verts
- 00 Gt to Cobra brakes swap
- 4 v cobra rebild
- Lincoln 9 inch in a Fox body?
- BBK Longtubes: Do they have EGR Bung
- Por 15
- i got hit!!
- 94 cigarette lighter fuse location
- clutch fan questions
- head gasket
- Tach stuck at 3000
- speedometer help needed
- restoring trim
- Rear bumpers... please explain...
- Identifying stereo wires
- Chip reburns--where?
- Who reburns autologic chips
- Any one have hook-ups on nos parts
- Just got my new Heads!!! What's a good RWHP estimate?
- ect???
- Blow-By
- need help with a part
- HELP----Who fixes a/c????
- lights acting weird
- Smaller chassis shops in the area
- please show me how to put my picture with name
- 86 with new thoughts almost back on road
- Which trans for the strip?
- R-12 And R-134?????
- Supercharger question
- who know a site or a place for conversions....96 or newer Cobra motor?
- Does anybody have experience with the holly 174 powercharger
- Crashed my 93 coupe...
- Do Lock Actuators Get Crappy?
- Converter re-stall?
- What can I do to improve my 60ft......
- need 373 gears, ne1 know a buddy with a lift
- anyone heard 1 chamber flowmaster?
- in desperate need of a 96-98GT caliper bolt
- Can you pass Emissions without ERG connected
- ignition switch ?
- auto hp numbers
- Suggestions for a 93 coupe
- time for a Radiator
- will a 285 fit on stock bullits?
- will a 285 fit on a stock bullit?
- 4-lug rear disk problems
- Anybody using a PA SFI bell for C4?
- What type of refrigerant do I need?
- Clutch cable problems
- SVO differential cover install
- Dyno questions...
- what struts to use.
- Where to get my crank turned? HEB area
- Who sells Welds cheap?
- Is a main girdle really neccesary?
- 03 Cobra's
- Welds or Bogarts?
- Who here has 90/10s? And drives on them everyday.
- Questions about engine swaps
- Fox owners inside
- Where to buy O2 Sensors for my 95 GT?
- ****who has a 90 hatch stang??****
- Major problem
- Broken Fluidampr
- Timing Problems?
- license plate question
- New gears!
- Contour problem
- Need to Harden Gears...what to do?
- what heads are on s 84GT
- AFM intake and pipe wraps
- Someone just left this on my front porch today!!
- Question about ARP rod bolts
- Think you have a big air filter? You don't.
- Your thoughts on the King Cobra Clutch?
- SN95 Suspension on a Fox chassis
- Suspension Problem
- adjustable rear shock?
- Breather Question
- 15" Draglites (or others) on the back of a Cobra?
- Gear Installation ?
- Minor AC Problem???
- windshield trim
- What the hell is this?
- Inspection?????????
- What would compression be with flat tops and 64cc heads?
- Some general questions/comments about 351 balancers
- Downshift and no gas = stalling?
- on the ground
- Show Car & Truck people
- What puts down more RWHP
- Grinding noise after car starts up only after car is hot?
- Timing Adj
- some people are thinking I am ozzeran....
- Dyno results: So close...
- Rivet Gun for hire?(Need to borrow one)
- Front seal on superchargers
- removing a weld?
- silver car dyno results: shorties RULE!!
- tps?
- Long Tubes for AOD
- **sn-95 computer change ?'s****
- Valve adjustment on pedestal mount rockers
- car has been sitting
- Fuel tank question? Sending unit??
- Best Cams besides Blower cams for the 98 gt?
- old hermonic balancer
- Door lock
- boosted guys-- map sensor question
- compression ratio
- 1 3/4 Longtubes...???
- Anyone heard of FTI cams?
- track times?
- ok...... any other ideas?
- Question about blower pulley's........
- Spring help???
- Stock 5.0 Spark Plugs
- compression ratios
- Exhaust Problem
- quad shocks?
- Which cylinder is number 1????
- Explorer Heads
- I.D.ing a T-5
- Transmission Bearing
- Need to get a bottle filled in Plano
- Anyone make a REAL 16" slick?
- Everyone with the RPM upper and lower intakes....
- Which side is "bank 1?"
- Think this maf can be fixed, and a pic for Forrest
- Twisted Yoke II
- This blows.............
- good place for head work
- Cam Questions
- Replacing door locks
- 302 into an lt1 car?
- Holeshot wheels...anyone use them?
- Wade's Converters any good??
- A/C delete question
- Tires
- New here, Have some questions
- what should i gap my spark plugs at
- Swapping Trans
- mustang interactive
- Ideas on 02 Explorer wheel upgrade?
- GT-40/PCV question
- Pro3i camber/caster plates
- Where to mount MSD-6a ?
- Idling ???'s
- Wichita Falls area SN95 owners help
- Post Long tube dyno....disappointed..
- tracking down a vacuum leak
- What's the time for the fastest stock foxbody
- Car won't start
- New Dyno numbers for the Harley
- Timing issues???? HELP!!
- Valve Clearance?
- Dyno results
- 17's on a fox question
- carbed 393 cid
- Quick question
- Anyone have this tool?
- Cam decision on 331?
- exhaust fitment question.
- AOD questions
- Got to start all over got ripped off!