View Full Version : The Garage
- head swap
- Fuel pressure
- Best Exhaust for a 5.0?
- Need help with idleing problem.
- 60Ft. mark question
- new times
- approx weight of 5.0
- Roller rocker install question
- Diablo Chip Question.
- Bassani 4.6 shorty headers
- Anderson PMS vs. Tweecer
- Think it's safe to do a 351 turbo?
- Finally found a set of wire looms that I liked.
- Tips For Better Powershifting??
- ? re: GT40 Lower Intake
- 1.9 0-60 possible??
- Any EEC-Tuner gurus out there?
- my car sucks
- tesioner
- T56 for 5.0L Mustang
- 95 Mustang 3.8L
- MM&FF Ported 4.6 upper?
- can aftermarket solenoid damage computer?
- Clutch Problems....
- How much Nitrous can a stock 5.0 hold???
- Tranny performance
- MSD wires
- hey Guys need some help on tuning
- loose front on svo
- T5 boom bitch. Use these pics, can you see the prob?
- Making hood scoop functional
- steel bearing retainer for a 4cyl t5?
- what tranny fluid to use in a tko
- computer?
- dyno tuning?
- Need Brakct Asap!!!
- What causes ABS light to come on
- how to look for trailer wheels...
- SROD bellhousing on a tko
- a few questions bout stangs
- Reichard intake 99+
- Ford Part # look up
- HELP: installed the tko, but now I have a problem
- Modded 3.8 overheating..... ideas?
- I think I fixed the cobra...
- install of 4.10's
- Weird sound coming from underneath car...
- Anyone Good With Electronic Installs??
- Boost Controllers
- repair manual
- Anybody had any experience with the Gforce T5
- Water Wetter???'s
- Install of Poly Trans Mount?
- A/C help with a '98 Cobra.
- My car is going nuts...
- What kind of Mustang is this?
- My new intake...dial up beware....
- 5.4l -> where is the &^$%#* PCV valve? (on the road need help)
- Stripped screw, how can I get it out now ?
- drag race front suspension set-up ??
- GT front nose on a coupe?
- 5-lug conversion, front rotors...
- TFS track heat info needed
- nos jets
- dumb question..carfax report recieved
- New Trick Flow RACE HEADS
- Everyone with Convertible Mustang experiance>>>
- injector question
- Getting Pissed off at the new motor, help.
- Driver's seat
- Bullitt Vacume Lines?? Need Pics
- Does Anyone with experience with the EEC-Tuner want to accompany me for a dyno tune?
- Has anyone here painted thier own car?
- Cruise control vacuum line
- How to change ignition lock set without keys
- What Should I expect my car to run?
- Best radiator and/or fan for 5.0?
- Haunted 4.6
- Hypertech?
- A/C Questions
- Check Engine Light
- Novi 2k Blowers?
- possible ecm failure?
- More problems with this ford....
- where to get wheels chromed
- need help on choosing a mass air
- New compressor not kicking on, what to look for(?)
- 04 Stangs!!!
- Reflowed injectors (36# to 72#) High imp
- 5.0 Internal questions
- gt- 40
- average times for a 2002GT 5spd?
- any local shops carry 94-98 Saleen style bumpers
- Exhaust ?
- Anyone know the part # to a replacement cap and rotor for MSD
- how to install my cobra upper intake?
- Need some help on Valves
- SN95 K-member in a fox?
- Wally World R-134a conversion kit?
- Cheapest place to buy connectors?
- DAMN COPS! Best RADAR Poll
- Slicks on the IRS??...help me out
- AOD transmission stuff...where to go?
- if the IRS can't handle it....then lets build me a solid axle!
- She's Runnin!
- Tokico Struts
- How to tell the diff AOD vs AODE
- T-stat question
- 03 headers
- What do I need to know about replacing an LS1 clutch?
- Stripped Oil Pan Bolt Head?
- Sump, Cell, or stock tank..... what's the school of thought....
- Flooding 5.0EFI
- Headlight Question
- how to install door handles on fox?
- Where to find a cheap blow off valve
- Where to get my block fixed???????
- 01 stang a leanin' what can it be?
- Help still rich, changes so many things
- brake place
- Alternator Pulley
- Lug nuts for weld draglites.......?
- shift points?
- Need a Dyno.. Where to go??
- How do/should I bypass the Nuetral safety switch on a '95
- 4.6 to 5.4 swap
- Need opinions on what color blue to paint my car....
- Just got back from Speedworks...
- Just a little more...408's new intake
- Tips for installing a TKO
- Cobra mass air question?
- Can you buy Tripoli and White rouge at auto zone?
- gt-40 explore heads on a 92 5.0
- Bending 1/2" & 3/8" tubing
- nitrous jet ?
- T/O bearing retainer for a 4cyl t5?
- help new member
- Help me with my math!
- ProChamber vs DrGas X vs MRT Stainless H
- Car dies when I come to a stop
- Power Gains from Changing A/F Ratio?
- Will non-emissions legal heads cause EGR codes???
- Installing RCI seat in a fox body
- Anyone Wrenching for $$$???
- Where did my oil go?!
- Front sway bar ?
- PMS MAP sensor/ N20 ?
- Subframe Connectors
- How much of a differance
- Electrical Question
- I was window shopping at Majestic Turbo today...
- '94 F-150 help
- Idle problems. 500 to 2000, 500 to 2000.....& dies
- Looking for Decales, Anyone know any web sites?
- Mac Upper and Lower control arms
- Next Mod??
- Which Fuse?
- need to have someone swap gears
- Eng. ticks badly
- Victor Jrs???
- f303 cam question
- 351W Clearances
- Foxbody or SN95??
- girl in desperate need of an engine
- Fuel Pressure Issues - Riddle me this!
- 2v shortblock needed
- mont owners or 2.3 owners inside.
- 5 lug conversions Why???
- HELP!, my h pipe is loose
- which intake?
- Brodix or Canfeild Heads
- jet chart for NX kit
- Pro-M Optimizer..does it work?
- how much horsepower?
- Good nitrous kit?
- CV Axles Where To Get Installed
- No start condition....any ideas...
- Anyone ever heard of Wico Racing transmissions?
- what do you think?
- SN95 ride height?
- Aluminum Radiator Decision
- 5.0 distributer? cast or steel?
- Help!
- Some Quick Questions...
- Skinny Kid manual brake adapter
- Looking for Powdercoating
- question about replacing distributor...
- Mass air? Which one is the best?
- Leaking TR-3550 . . . on top
- Performance Question
- Victor Jrs or AFR 185s
- Anyone know the link ....
- oil scavenge pump for low mount turbos
- Any one have problems with exhaust with a tko
- Rear end play
- Any way to fix speedo with this rear end?
- O2 Sensors
- How hard to change 03 H-pipe
- nos?
- Jumping Speed Bumps, broke motor mount
- Gear difference
- electric switch for lockup converter?
- fuel pump part #
- Axle ????????? Help please!!!!!
- Burning oil
- Which tranny would be better
- Its ALIVE
- tips to install new rear axle studs...
- EFI swap to CARB (parts list)
- Alternator charging too much
- Who ceramic coats headers locally?
- How hard is a 130amp conversion on a Fox?
- Fresh blown motor!
- Crane Ignition
- 99+ gauge cluster help
- S-trim upgrade
- Battery light flickering
- gear
- dry or wet type cheater system
- Brake upgrade?
- Help with poor drivability
- Gas tank filler tube grommet
- Got My New Hood
- A/C system guru's....question
- Problem with GT40x heads
- Brakes!
- Weight Reduction Question?
- does anyone have
- how to check fuel pressure
- T/O bearing maybe?
- Injectors not firing...repost for the 90348650th time
- 17x8 Bullits on a 65 stang?
- *** tranny on a 93 AWD Eagle talon turbo?***
- Question on used t5
- ? about fox rear bumpers
- Best H/C/I 5.0 Combos??
- I Hate Cats
- Orange antifreeze & distilled water ?
- Morgan racing engines?
- $$$~Need somone to help tear down motor TOMARROW~$$$
- Egr Delete?!
- Anyone Need Cash Tomarrow????
- heads are too big????
- Best Riding springs/shocks?
- HELP, You make the call...
- Convertible Top Motor
- Good info from Gary @ Weldon concerning line size
- Backspacing
- Roush 180/200 Heads
- Power from aftermarket Intake on stock motor
vBulletin® v3.8.1, Copyright ©2000-2009, Jelsoft Enterprises Ltd.