View Full Version : The Garage
- Popping though the intake? Any suggestions?
- Having idle problems
- Valve Train Question
- exhaust??
- What part number for NGK tr66
- T56 Parts
- Help! Clutch/Tranny problems
- Why do some folks talk bad about the PMS?
- NOS 175 jet size
- where to go for a converible top
- Where to get 2 valve heads ported?
- another hood ???
- Poping sound after car is off ?
- 3" inch exhaust - for 99 Cobra with live axle.
- got a question
- Pulley question
- Exhaust work? - any GOOD shops around town
- design concept hoods
- MIL question
- Who was having wiper issues?
- New Number
- What do i need, besides the A9L, to swap my '95 Computer to an A9L?
- window tint
- will 4.5" backspacing work...
- what flywheel ?
- Inspections and Alcohol?
- Help identify trick flow head
- anyone have any sn95 brake lines
- how fast
- Need Help again....
- starter solenoid help
- Best place for a front bumper cover and/or hood for an 86 GT?
- ATTN: Manny
- how do you pull an rear end axle of an 02 GT
- Cooling problem
- inspection
- Tuning an older car w/ carb...need help
- Failure: Code 174, Lean Bank #2
- What is the maximum cam lift for OEM HO roller lifters?
- engine blocks
- 351 cleveland in a fox body
- Tint options for fox sunroof?
- 351 into 1999 Mustang?
- Driveshaft interchangability
- A/C Help!
- Fact or Myth? You cannot change back to regular oil after synthetic?
- Air/fuel gauge install?.....
- Battery/Alternator/wiring problems
- How much?: used upper/lower intake...
- Poll: X Pipe or H Pipe
- catylic converter problem
- Dumb Question - Injector Size
- Modding engine w/blower....
- Check Engine Light?/02 Sensors
- Truck lower intake ??
- proportioning valve
- What gasket?
- Need Cowl Hood Paint Hook Up
- 87-93 bumper support fit 84,85 GT bumper cover?
- Motor Help
- Top dead center ?
- 68 302 vs 91 302 parts interchange ?'s
- Alright Guys...Cam question>>What do you all think?
- Lane or Hoosier Tire reps
- Engine Create
- looking for dyno tune already have chip
- Plasitc Chroming. Lane?
- timing question
- The engine buildup has begun!!!
- Can someone give me some boards similar to this one
- Vortech Intake
- FMS alluminum driveshaft
- ? regarding springs
- Think I found the "ticking" noise (long)....machine shop recommendations?
- AOD valvebody?
- Edelbrock Performer Heads: Valves
- bullitt install on 96???
- ABCexclusive???
- Metal buildings/shops?
- Roller rockers!
- dohc head question
- A/C guys inside
- 93 2.3l question
- ** any possible way to fix?**
- whats wrong with this clutch?
- I need driveshaft work.
- 99+ with autometer gauges
- hey from philly
- Who does spray-in bedliners for pickups?
- electric vacuum pump?
- help car running rich, with no codes
- '03 Cobra mods....
- CHEVY cam recommendations
- I need help on my idle problem!!!!!!!!!
- Fuel system recommendations for 600hp....
- I say again....I Hate Long Tubes
- Questions about Stroker Kits
- Tires
- Lowering Springs
- EGR ???'s
- Does anyone know the optimal oil pressure
- core support?
- I need nitrous....
- what would the e.t. be?
- stall converter?
- Poll!!!! What body kit looks best?
- Where to buy boost controller? :D
- Best Long Tubes for 97 cobra
- What all comes with the MSD 6BTM?
- racing/rally stripes
- c4 input shaft ?
- Brake line/braided???? Input needed.
- ** well i switched motors**
- question on type of spark plug to use??
- MarkVIII fan install
- Keith Craft?
- H pipes with cats ?
- Are there any 'Power Window Gurus' in here? I've got a prob...
- Long rod 393 vs 408? Comments?
- Which EEC A9L or A9P???
- New Convertible Top
- Black sealant for taillight lenses, what's it called?
- aftermarket shifter for 99+ (automatic)
- Does FMS J302 heads...
- Relocating HVAC controls into the Ashtray compartment.
- Anyone Weld?
- Can I use Twisted Wedge - R's?
- what is stock d/s length
- How much timming does everyone run?
- Machine shops for Modulars?
- Need A Good Muffler Shop
- CDC Side Exhaust 275.00 off - GP
- Car fixed dyno #'s inside
- Hood pins....
- autocrossers, road racers, SCCA- F body ABS q's
- Can someone tell me what brand and size these injectors are real quick?
- X3z Eec Iv
- Don't cut drag springs...
- Can't shake this rattle, help!
- whats wrong :( :(
- Aeromtive fuel systems.?.? Cheapest Place?????
- Another bug gone: Rev Limiter
- My stangs got a little smoke coming out the right tail pipe..
- carb/ignition help...
- Why Do People Say?
- 03 cobra guys in here!
- 92 coupe rear seat delete????????????
- **help!** oil problem**
- Help! Fuel pump on when ignition off
- Can't Get My Door Unlocked!!
- Any got a pic of...
- Running on 7 cylinders. Need Help!
- 95 Mustang
- D**M emisson stuff
- Transmission Fluid quest.??????
- Pro M or C&L MAF?
- Rear Sway Bar: Does it make a big difference?
- What would it take from my 98 gt to beat an LS1 0-60 ?
- Changed mid pipe and.....
- Electric Fan relay help
- 5.0 stroker mod motor?
- 65mm throttle body vs. 75mm
- straight pipe .vs h-pipe
- 91 5.0 carb dist ?'s
- Changed plugs
- Does anyone know of a good home Theater forum
- What do I need to change out my shocks ?
- stalling problems!!HELP!!!!
- what is the strongest stock rod...
- Help need door lock actuaters today
- would y2k cobra r wheels fit on a fox?
- Anybody know anything about Granadas?
- Are J302 heads any good?
- Rear end noise, what all do I need to rebuild ??
- Should I get a Tweecer Rt or use my Auto Logic Chip?
- Attn. Turbo guru's:
- auburn or power trac
- ???4 banger swap to V8????
- What is a good price to pay for someone to change my transmission, etc.....?
- Cam comparision
- Stock piston question...
- Griffin 31"x19" radiator install complete
- mass air screen removal.
- Help
- Needing some opinions...
- I can't get my springs on!!!!
- C4 conversion???
- Gears?
- More TO bearing woes
- What to do FIRST...???
- Shifter Knob
- **oil coming out dipstick tube**
- Fuel injection to carb conversion.... can it pass emissions?
- 347 ?'s
- exhaust sound??
- What problems would I have if I pulled the 357 out of my 95 and put it into an 88?
- Not Sure...
- Clutch on my '02 GT
- Pillar Arm Pods
- SN95 6pt roll bar by LoneStar Performance
- heads question and what else do i need
- Best wheel polish
- good tint
- Where is the best place to get my s/c installed
- Rod/crank question
- What are the chances of my flywheel being out of balance?
- Shorty Headers, how much of a difference?
- tranny mount (other ford)
- What's the secret to get a 351W, w/ a tall EFI intake, under the stock hood of a fox?
- Are these good heads ?
- Saleen supercharger?
- redoing front suspension - HELP
- Where can I find this relay?
- 95 tranny harness
- Difficulty ???
- dropping an ls1 into my....
- need help with new combo
- what could this be?
- Paging Econodrag
- help still rich
- compression ratio?
- repairing bumper cover
- window tint
- Mod!! Oh No!!
- Vortech SQ
- Need bumpers painted
- What gear ratio should I go with?
- V8 Conversion
- Carfax---
- 93 Cobra exhaust question
- anyone used vinyl die on their interior?
- cam degree questions
- More fuel?!
- fuel pressure gauge
- 94 Cobra overheating w/ AC on
- 4.6 question?
- Where is the Turn Signal Flasher
- headwork on 98 4V heads?
- Need a chip?
- what kind of times with this combo
- Fuel pump install on 91 GT
- clutch noise
- need pics of belt routing, with no AC and PS
- ** what should i build?**
- What is going on with this Mustang?!!
- fow rear end in a 99+ car?
- EEC tuning options - 02 GT
- Why is this car so slow?...
- Whats the best Stainless Steel polish???
- Where to get 2.5" SS pipe?
vBulletin® v3.8.1, Copyright ©2000-2009, Jelsoft Enterprises Ltd.