- Need brake lines
- question about a cold air kit for 99+
- which shocks/struts for my car?
- speed density questions...? pls help!
- SD auto coupe...any help?
- Which is best????
- fuel pump questions.....
- 460 foxbody
- Bullitt info????
- anyone ever changed a steering wheel? fox body
- How long is the belt with underdrive pullies?
- Tremec tranny?
- 351 and turbo ?'s
- anyone done this?
- Firing Sequence on Mod Motor
- Price for 42# injectors?
- 94gt should i go to a fox body computer or a saleen computer ??
- Thoughts on Holley Systemax II kit?
- can sn95 take 17x10 wheels with 5.95" back spacing? w/
- Which rear sway bar
- Your cheap junk yard mods
- Swapping heads......
- explorer intake question
- Silencer on a 98 Cobra
- 2.3 Turbo Tuning
- I'm stumped....
- Cobra Cams Spec
- Tubular K member and lower motor mounts
- Question 351
- Tranny Cooler?
- EEC-IV help Quick!!!
- Clutch recommendations?
- FMS Aluminum Driveshaft Question.
- what cam to use
- f 303
- emissions legal cams
- Can Houston Performance do P&P?
- c4 tranny
- what color are 24 lb inj.asap
- Vibration problem.....
- 302 or 351?!?!?!
- What are the pill sizes for a Stage 1 Dry Kit???
- Any C-clip/axle Veterans
- head and intake gasket questions?
- Which junk yard cars have electrics fans that'll bolt up to my 90 coupe?
- 302 vs. 351
- Ratios for Stock T5 tranny.... anyone know 'em?
- Need stock piston/rod/stroke info....
- Eec Iv And V Tuner
- Safety concerns about widened alum wheels.
- Why do I keep breaking clutch cables?
- Air and fuel question?
- mass air
- Need stock piston/rod/stroke info....
- Voltage fluctuation
- car running hotter after underdrive pulleys install: is this normal?
- Road Noise?
- True or false: Torque peak must occur before horsepower peak?
- where is the thermostat on a 4.6 cobra?
- NE1 got Jacob's Omni-Pack instructions?
- MAC Cold Air Induction Kit
- Opinions needed:Who burns good chips?
- Width of TC rear (housing) vs. Stock rear (housing)
- True or False....
- Wheel Question
- Whats a good shift point on my stock 1990 Coupe
- Wiring Harness Replacement?
- Charging Problem
- Compression Calculator
- how to change your oil.
- quad shocks
- Think my water pump is crapping out
- What's better? 7/16" rocker studs or 3/8" rocker studs with a stud girdle?
- Anywhere LOCAL to buy new Quad Shocks?
- I dropped my Oil pump D.S.!!!!
- Idle probs
- 7.5 to 8.8 Rear End Swap
- 85 to 93 1/4 glass on coupe swap
- Pill sizes for the NOS 5171 kit?
- where should I buy longtube headers for a 96 cobra? n/m
- Cam Question
- Gears
- Whats a good oil weight for winter and how much of it?
- Can you use solid roller lifters on a Hyd. roller camshaft?
- Driveshaft geometry during hard acceleration?
- EPEC is available now.
- NOS Experts Please
- Mobil 1 filter question
- B&M Shift Kit
- Are NGK TR6's good for 4V Cobras with N2O?
- Sos...sos....sos......sos......sos......sos...
- E cam
- Hooking up!?!
- SUBFRAME connectors
- TORQUE boxes
- Which wire do i hook my A/F ratio gauge up too?
- 347 injector questions...
- 5-Speed or Automatic?!?!?!?!
- Cheap thrill
- Rebuliding 4.6 SOHC questions
- Prostar maximum rotor size?
- Help with 5115 dry kit on an 01 GT....
- need help about gt40 upper&lower
- 460 into fox swap
- Any suggestions on local trans shops?
- 99-01 peeps..gota questoin
- Whats OPEN loop mode mean???
- 94-95 Cobra 5.0!!!!!
- Can I put these 1.7 roller tipped rockers on a car with a F-cam?
- 5-Lug Conversion
- can this be done?
- Springs - Lowering and/or handling?!?
- General feedback wanted after visiting Ford Performance Racing
- Dis-4 ignition questions.
- question about GT-40 heads
- Roots or Centrifugal? need advice
- Car Trouble Again...
- Rear Brakes on Cobra
- Break in reccomendations..
- what is a good clutch?
- Suspension ?'s
- How do i get to Dallas Mustang???
- running so rich my eyes burn
- Vortech rebate 'till 12/31
- How often should you rebuild NOS solenoids????
- $174.00-clutch cable from Ford!!!
- Looking for some reading material....
- 8 rib system
- Tire/Wheels
- Need Pictures of ABS exciter rings
- fuel regulator question
- modular N20 users
- will pulleys for a96-98 fit a 01?
- some stupid basic super/turbo charging questions
- Why does my tach needle shake so bad???
- B cam VS E cam
- Where to get Superchip reburned for 01 auto GT
- School of hard knocks or whatever it was?
- what do stock heads flow?????
- Can someone explain to me...
- mufflers
- Cutting my Eibach Springs
- My oil pressure jumps around....
- Bigger injectors/high FP Analysis...kinda long.
- Idle issues!
- BBK Long tube Header Install???????
- Cam question...
- Nitrous
- S-Belt ??????
- How far is too far on stock heads?
- Fuel Pressure/spark plug gap with a blower?
- Can this modify be accomplished????
- Inspection stickers
- help out a novice
- Check out my theory
- Quietest H.P. Muffler...
- NX ADJ.75-150 Kit
- Suspension??????
- Valve to piston clearance question
- Anyone have some time?
- I want 115mph on motor...how do I get there?
- What do you think it will take to see 115 on the juice?
- Question on NOS Bottle Openers
- headers or cam
- Gears?
- DSS or CHP?
- 306 vs 331???
- Headers
- Can ne1 help me?
- Fox Fender Bolts...Where are all of them?
- Can you delete your o2's totally? Would it be worht it?
- Running w/out thermostat....
- Need Help with water temp. gauge
- Can anyone fix this??
- RAM AIR CONVERSION help
- Calling all nitrous cars
- NEED HELP ASAP please!!!
- Ram Air Conversion Help
- Holley????
- Proceedure for swapping axles
- wiring harnesses b/t 89-93 and 94/95 differences...
- NE1 put 87 1/4 windows in a '86 coupe??
- How do the clutches in 8.8 work???
- Belt too tight??
- Starter troubles...again
- Battery Re-Locating to trunk, too much wire??
- Help! How to move a car locked in gear
- Shaved Engine Compartment...
- Removing Windshield Wipers...
- My electric fan 'works' but it has issues.
- looking for opinions
- Can I install new syncro's myself?
- Difference between 85 and 93 fenders...
- 85 Bumper Reinforcement work with 93 cover?
- QUICK....rocker arm stud torque lbs.
- 3.73's to 4.10's?
- Setting Stud Mount Rockers?
- Starter Solenoid
- Thanks guys
- Fmu Or No Fmu??
- My doors are a pain in the .... they dont close right
- mufflers
- Fuel pump relay
- Questions on Forced Induction setups, and 351's...
- 4.6 head swap
- nitrous ?s
- new cam,whatcha think?
- Juice question...
- Juice question?
- Removing Clear Silicone...
- New Slicks
- Need Tranny help!
- header question
- watch the bouncing speedo
- Will a slipping clutch alter a dyno reading??
- Should my transmission be blowing up????
- What if...Injector size is same with MAF's calibration on SN95 Cobra
- 3.73's
- Mac vs. Flows
- Fuel pressure drop
- Driveline Problems, Please Look inside
- rear end Q's...asap
- Question for PMS users...
- Car shakes braking from highway speeds...
- 3.90's for the 8.8" ?????
- 87 speed denisty with 70mm tb
- The Death of Cams?
- Which cars have good electric fans?
- Locking down the stock distributor?
- Swapping doors and fenders...88chris, get in here..
- Is my T-5 strong enough for this setup???
- e303 + 1.7's + stock short block = ???
- anyone else think the "ball & socket" exhaust design robs power?
- Droppin a 306 in an 01 GT??
- Driveshaft on 7.5 the same as 8.8???
- Gear ratios of C4
- Poll: Safe or Unsafe
- Disconnect/Reconnect Power Steering Pump
- Gears, what kind, where to purchase
- When you turn my car off it takes a second for it to die
- Aftermarket Door Lock Actuators and Window Motors
- Who actually seen a Tremec 3550 output shaft?
- Question about a dry shot of nitrous...
- Stupid Question: What is a Windage Tray for?
- Voltage Problem Please help
- Help Running Rich as HELL
- Launching w/ Slicks and an Auto...?
- question aoubt gauge cluster for fox body
- Do they make upgrade parts for your T-5????
- Interior and Door hinge questions.