View Full Version : The Garage
- Exaust leak= Stuttering?
- Cutting out? Blowing out spark? Clueless! HELP
- 255lph fuel pump and regulator
- Engine block orofices
- A/C on idle flakes out
- cheapest place for PI heads
- SN95+ steering wheel in Fox ?
- Cam Question
- cheapest place for PI heads
- Good source for 36# injectors
- what size bolt screws into the back of the block when you remove the smog pipe?
- what size intake gasket so i can open up openings?
- How to clean clogged fuel line?
- what is the best way th clean carbor out of a stock upper intake?
- AN1 know the available thickness of popular 351 head gaskets??
- wire wheel good for taking the paint off of an intake?
- maf above maximum voltage
- Anyone done a T Bird rear end swap?
- what all do i HAVE to reconnect to the upper upon reinstallation
- What times should i be expecting?!?!
- tranny shopping
- Bored......so I did a quicky clean on the motor
- Mass air conversion help
- Are headliners tough to fix?
- What to clean O2 sensors with?
- Cam in 94
- Aod to T5 swap????
- Just polished my first piece of aluminum
- FRPP vs. PI HEADS
- Frustrating
- SN-95 dash in Fox
- Injectors not spraying???
- Does anyone know the range on a ford ACT?
- 351w Vortech - interesting old magazine articles/dyno
- k & n filters
- 1:7 rr's w/ E-cam on stock hds
- What Numbers????
- turbo gurus
- Ngk Tr-6
- Heatercore Repair
- Aluminum vs iron heads
- smog port ?
- Intake?
- any info on city garage
- Already melted a new plug wire
- Best places to get auto glass done ?
- looking for someone to swap my heads?
- how do you remove an air bag steering wheel from...
- attention forrest:
- how do you get the pass. side air bag off?
- clutch problems
- ****** intake help
- Dyno results w/ problems
- Turn signle questions!
- What sounds better?
- What next?
- wow..wtf is that smell
- Has NE1 used a weld on sump on a stock gas tank
- Valve sizes
- cheapest clutch repair
- Fuel sys. questions
- Throtle body cable?????
- does no one make a correct size t-body gasket!?!
- Need help on my '66...
- 5.0 engine swap
- Did Some Home Porting
- question
- buzzing from msd coil
- Who besides DMann tunes in Dalls
- Should I keep the cast pistons or buy new forged pistons?
- **any one ever replaced door handles on a fox?
- do 1.7 rr's add any horsepower?
- Any upcoming dyno days??
- Best place to get window tint?
- Got a problem??
- Tranny Jack
- Can a 85 stang w/10.5cr pump gas motor go 8's?
- Power or Manual?
- Oil cap breathers?
- what will this lift be with 1.7s
- 351w Heads
- converting to a 5 speed
- best place to get fms gears
- K-Member the same on.....
- 13" 4-lug rotors?
- Intake Question
- Broken Belt Question
- Batt. relocation guys get in here!
- What would it take to get...
- engine swap....
- Cleaning up oil...
- cooling system pressure test?
- Let's compare my soon to be new torque converter
- Car is running fine now?!
- Gear Install!
- Electric Defroster???
- Awsome TOOL SALE!!
- Buy a pair of Bosch O2 sensors and get $20 back?
- I Passed Emissions Today!
- discount auto power steering rack???
- Anybody wanna help me pull my motor
- Where to buy flasher?
- What are the brightest headlight bulbs out there?
- Anyone buy the "Sport" steering rack from Autozone?
- 2nd gear gone
- Need hookup on steel braided lines and fittings
- Where can i get 80/100 watt headlight bulbs? How Much $?
- Tranny Cooler Recommendations
- Lenco Engine Builders
- Oil Gauge!!
- how do you get the passenger side air bag out.
- Conversion Help
- coolant temp
- Rim widening?
- stock with NOS and gears
- Help, PLease...
- question about an SHO
- QA1 k-member help!
- interior
- Couple of Questions? Any Help...
- How much to install gears on an LT1
- quieston about my car at high RPMs
- Car wont start...Help!
- longtube headers????
- Who sells girdles in dallas?
- Help me locate some stuff......
- What could this possibly be? Cutting out issues.
- ARGG Intake Manifold Bolt
- Will this distributor work?
- To Void Warranty questions
- Info about s/c needed!!!
- Whats the best engine degreaser?
- Wrong parts for fuel pump?
- will an A9L hookup to 94/95 dash gauges?
- local junkyards with new stangs?
- Supercharger Question?
- Meiziere water pumps???
- How much boost can I get......
- trans rebuild
- 351w in 84 stang (install ?)
- Is it possible to make 400rwhp with a Torker 289 intake?
- swaybar?
- Mechanic Wanted!!
- Head Torque Q's
- Short Shifter Problems!!!
- Who does car alarm installs?
- failed emissions-how to pass?
- Need help (not sure with what)
- Fuel pump???
- PLEASE HELP: New problem with electrical system
- rebuild kit??
- Stock GT 1/4 + Dyno #'s ???
- Any local P&P Shops ??
- Car almost done...check it out! :)
- '91 3 row radiator in a '94?
- Is this gonna f**k up my motor?
- Dyno results on my Vortech GT
- Coolent Out the Radiator?
- ANYONE that has built a 302 COME INSIDE!!! (5 ?
- Has anyone spliced the T-Rex into the factory fuel line, if so WHERE?
- Best thing to use to remove carbon from pistons?
- Where to buy and put check vavle in vacum line to PCV
- Turns out I didn't spin a bearing after all....
- Tweecer
- Someone Help Please!!!
- Head Gaskets for TFS TW heads
- Battery problems???
- Who sales H&R Springs in the area?
- Superchargers vs. warranty
- Lighting Mass air meter or Pro-M
- anyone installed shaved door kit b4?
- Help. Vacume tree gone bad!
- adding mods @ 140k
- Help !!!!!!!
- Help !!!!!!!
- 4 cyl. to 5.0 conversion
- supercharger Q
- tire question need help!!!
- Lowerd car, Need tire rubbing help!
- Now I've gone and done it...
- Low tension or standard tension oil control rings with blower?
- Do I Need Custom Headers!!! Please Help!!!
- Do I Need Custom Headers!!!please Help!!!
- Help! WTB?? i need 1 1.6 RR asap.
- Cold Air or Ram Air??
- We decided to keep the cobra boosted!
- need alittle help please.
- Ford Recalls
- intake off?
- 99+ Tach and Autometer Tach adapter problems.
- where to get quality battery relocation kit?
- What kind of paint to use to paint 93 pony wheels?
- Exhaust MPG
- help!!!i need a title
- painting heads?
- puttin new cam in
- Fuel
- couple of 351 questions (not swap ?'s)
- Head and intake questions
- Where to buy a check valve?
- Any " Real Difference in fuel pumps?
- More power
- Flywheel dilemma
- whats involved in changing the radiator core support?
- TFS Valve Covers?
- Car won't turn off, something in steering column???!!!
- About to buy this from Summit, need someone to look over.
- Anyone know a shop in DFW that can make Inlet/Discharge tubing?
- Cam/Rockers
- Who sells TFS Cams locally?
- Fog Light question
- new motor installation
- How do you fix the rear lower intake seal for good?
- 351w Stroker
- Flywheel 83-85, 86-93
- What aftermarket upper intakes will work with a stock lower?
- Need opinions- just blew tranny again
- Air compressor is too loud!
- Will a regular Pro-M MAF work w/ s/c
- checking TPS.....question?
- need help with exhaust!
- DMP MIL eliminators???
- 377 turbo running, but need HELP!!
- Codes,hanging idle,troubles
- Cartech website?
- Backspacing question
- f-bdoy guys need help with ignition
- Best place for AutoMeter gauges?
- Installing new rack, what else should be replaced?
- lowering springs installed
- WHEEL GURUS: I have a question...
- Calling all vert owners
- 4 cyl tranny mount
- who to buy a motor from?
- Head Code
- Homemade 5-lug conv.?
- Whats the best plugs to run in a 5.0?
- Homemade five lug
- Couple of stock Mustang questions
- Installing 8.8 in '03 Cobra
- Tach Install
- Too much cam?
- Ahh, need help on Four cylinder conversion
- High RPM
- Can a 8 inch rim support 275 / 40 /17 tires.?
- Got my PBR brake kit yesterday....
- could it be?
- TFI Module
- Car theft plug thimg
- ZR1 tranny question
vBulletin® v3.8.1, Copyright ©2000-2009, Jelsoft Enterprises Ltd.