View Full Version : The Garage
- K&N Fuel Injector Performance Kit - Generation II
- need help with a novi 2000 kit
- What do you think....
- Bullit intake w/ pro fogger
- Interior panels?
- Transmission rebuild
- Removing the upolstry on Fox seats
- Overheating problem.
- How do you determine rocker arm size?
- cobra intake
- Air shock hood prop
- DUI Wideband
- A/C eliminator bracket
- mass air problems (idle sucks)
- high idle when driving
- Need help figuring out car
- link for the shortbelt and no PS Question
- Ignition prob.----anyone help?
- what about this?
- Steeda pulleys and running hotter
- Advice please....this is really long
- 99 gt belt change
- Removing power steering
- who all hasdone the 4cyl. to 5.0 conversion
- New part for the '03 Cobra
- how many quarts go int 3550?
- Prochamber
- Looking for a Paint Shop for body kit.
- Intake question
- thermostat ?
- 3" exhaust piping needed to change from 2 1/2"
- Dont want to spend the money on the Supercharger.
- I need an exhaust hook up.....
- What should my hatch w/these mods run in the 1/8th and 1/4?
- Diff Fluid on my mufflers!!!!
- car idles bad when a/c is on
- SOHC to DOHC swap
- intake vatting
- door sagging?????!!!!!!
- |////| Advice for suspension upgrades. |////|
- 94 too old to SC?
- N/A hp
- manual steering on 93
- power steering question
- Best Place for Powder and Ceramic Coating
- what kind of hp?
- my header installation progress
- Spec Clutch
- Track times??? Estimates needed
- Carb to EFI pros and cons
- Anyone carry VHT?
- Torque boxes
- Ringing of Valve Bowl on Heads
- New Motor or Replace Oil Pump??
- Need advice on some rear end work!!!
- Cheapest place to buy a Procharger P1SC supercharger?
- Vibration question??
- mineral depoits in radiator.....
- 2 Questions
- Possible brake problem?
- 300/6 cyl. HP
- Oil Pressure???
- 3" or stick with 2.5"
- What cam would you choose..
- 281 n/a power
- 93 lightning help
- Mac catback?
- I've been installing something tonight....
- Strut question....
- which AFR's 185's or 205's
- what brake pads to get?
- Painters, got a question about primer...
- Should i do my alternator pulley also?!?!?!?!!?
- Turbo question????
- Dyno numbers 96' Cobra (ported heads & cams w/spray)
- DOHC owners, what temp do you run at normally?
- Seal broken on a Vortech Supercharger
- T-5s making noises, please help!!
- Blowers, cfm and hp question
- How To Open My Door!!!
- car hesitates then hauls ass
- Automatic Transmission?
- TwEECer Anyone?
- Plug wires
- aod fit 351?
- HOw much money on a projest car?
- How strong are 351W truck rods?
- C7 tranny?
- Does anyone know where I can buy blue silicone hose?
- How can I go about cleaning the carbon out/off of my upper intake?
- Anyone have a picture of their fox firewall with everything attached?
- computer ?
- GT Badges Getting Shaved
- 5.0 EFI Extremely Hard to Start in the Morning
- s/c pulley question?
- muffler question
- Help! Coolant Leak
- 408 stroker progress...
- Opinions on '94 Z28 LT1
- nitrous surging?
- More legroom with '01 Powerseat?
- damn heater core, need help!!
- paint jobs
- 3650 2nd gear grind
- Emissions Question, Is this a LOST CAUSE?
- what should i do?
- confused on what todo
- dammit, need a big favor in a major way!
- Paintless dent repair in/near Addison?
- What should I do?
- where to connect
- Anyone have a home made bottle heater?
- Tranny Question
- Rear Wheel torque vs MPH
- got the tremec in :D
- ***New Rear Wheel TQ Vs. MPH
- door panels
- Bump Steer Alternatives???????
- Are these ~89 saleen wheels on this 3rd gen f-bod?
- How do you think this would run???
- Car running way too rich, what can i do?
- ignition questions!
- How safe is nitros
- A-4 vs R block Whats the differance
- Just bought desktop dyno 2000 - this is a hoot!
- 03 Cobra Supercharger/Intake
- Ideas for nitrous switch location?
- need help on gears
- seat delete
- Water/Methanol injection?
- A4 Block Question....
- Setting Valves
- Who has a '96+ OBDII Car and has been Inspected recently
- Turbo vs. Blower
- Help!!!!!!!!!!!!!!!!!!
- clutch cable
- AAMCO Tranny shop
- ?? Good place to get gears installed?
- Can someone do a gear install for me?
- Help Me Please!
- New MIG CF installled on the r6
- got new dyno numbers today...
- Will a 94-2003 steering wheel bolt to a 92 column?
- main harness problem
- Help me decide
- How could I 'SIMULATE' a 93 cobra rearend? Use a 94+ rear? axle gurus within!
- problems starting car after engine is warm
- Cheap place to buy 42lbs injectors
- How to tell what computer is in the car...
- Syncromesh, yes or no?
- Cruise Control
- whats the best tire too hook up
- Help with Vibration
- Diff. between the 01 z06 and the 02?
- 97 Cobra motor in 95 v6 mustang
- will it work
- a pillar?
- Just bought a 2001GT.. what should i do??
- wierd knocking noise??
- anybody have pics of a SN95 with 17'' welds
- What flywheel/clutch kit is best
- Car Hesitating From 3K - Redline
- Igloo update/install pics!
- What are the best ways to start up a new engine...
- Glowing Headers....help!
- Just got all my stuff installed
- How much torque on a harmonic balancer bolt
- Carb to fit a 460...
- Saturn Engine Code Help
- Been Stroked?!
- motor mounts?
- c&l, cold air intake, pulleys ?? what first?
- Need help bad, please.....
- Where to go?
- How do I get the nut loose on the top of my strut?
- Good Mechanic
- another oil question thread...
- Turn the key, and the starter doesn't turn, or click. Starter solenoid or ign. switch
- Cleaning 02 sensors?
- what do you think of these tires?
- Motor doesn't turn over...different than ShawnQ
- pro-m meter
- What would a loose SOLID motor mount do?
- Stuck Passenger Window 88 GT
- 93 Cobra HELP!
- which intake to go with?? trick flow or holley?
- Fox body door windows, are they all the same?
- Why is it sooooo slow
- Where is a good muffler shop?
- Coil Packs???
- 5.0 reving to 7000
- FRPP Cobra -vacuum hose install?
- '76 Continental
- tranny gear ratios
- fuel rails
- wiring problems
- port work on heads??
- How do you get rings to seat....
- Misfire at Cruising Speeds (4.6L SOHC)
- 347 Ford Crate Motor
- New motor setup advice NEEDED...
- Quick question!!! Mil elems.
- Can a make 400 rwhp with this combo?
- Running dry
- Fuel Pump ? 255 intanke or 190 intanke and a t-rex
- Please Help!!
- Car needs help
- Heads/Cams vs Nitrous? Your opinions here!
- *****Does anyone have a stock H-pipe for a 96 Cobra?????*****
- Will 17" 94-98 GT wheel centercaps fit with a five lug conv.?
- help:fp not working when turning on key
- help me please
- BBK Long Tubes not fitting auto ?
- Pro3i LCA's anyone?
- Need year to year breakdown of EEC IV's
- Open headers or no
- stock crank and stock rods...
- Just finished assembling my 99 Cobra heads tonite....
- Custom Chip
- Questions For the car nuts
- 5-lug Question
- Is a 69' 351W bllock stronger than a 302
- 351W and a stick into a AOD 302 car
- Serpentine Pulley Conversion
- Nitrous
- I need a trailer.
- more motor mount questions.
- Should I go with "Total Seal" rings?
- Warning... DTA Racing steals peoples money
- Need a Donor Mass air computer for 5.0
- Motor mounts
- Where to get open ended lug nuts?
- what will be more benificial for my setup
- 5.0 Mass air computers
- switch to carb or stay efi....
- Just found out
- I need a bolt
- ok well Q/A time guys
- AFR 185's or Windsor Seniors Dart
- Someone stole my gas tank!
- Looks like I'm going to need an alternator...
- Where in D/FW area...
- Saleen Mod Help
- Another set back...
- Gorilla Locks
- Is engine balancing necessary...
- Throttle Bodies
- ABC exclusive?
- Need Input on Diff swap
- Oil Pressure Help!!
vBulletin® v3.8.1, Copyright ©2000-2009, Jelsoft Enterprises Ltd.