View Full Version : The Garage
- How low with c springs??
- Carburetor specialitist
- Need help identifying Roller Rockers
- Has anyone installed the '87 TurboCoupe 8.8 rear before???
- WINDOW TINT...
- 94 GT with Bad Idle.Help
- Which pistons are these?
- Question about my shifter
- Question about the 86 to 95 years
- Door Catch
- New 01 GT, help with mods!!!
- H pipe rubbing frame
- What if i yank the quad shocks off?
- Brake light
- 99+ GT timing
- 99-01gt back seat?
- The Cobra is back...problem resolved.
- weird tranny noises
- ? about p-1sc 3-core intercooler
- ecam and 1.7rr
- motor problem please help
- how to make an sn-95 hook What brand sub frames?
- Dallas Mustang Service
- Which Clutch / Pressure Plate For Me??
- Thanks everyone...
- Where can I get a driveshaft shorten ?
- Machine work
- WTF my fog lights dont work???
- Knock Sensor
- Have anyone done this?
- Mechanic recommendations in N. Dallas????
- Need to borrow carb
- my car won't idle with the C&L 73mmm
- Which motor mounts?
- notched pistons
- Exhaust Install
- Door Sag
- Vert and Coupe Rearend Questions
- 7.5 to 8.8 swap
- More mod question
- Help me decide on an engine....
- Anyone wanna change a rear main?
- Detonation and my spark plugs.
- Recomend A CARB !!!
- Rear Brake Drums for 5 lug Swap
- How do you test a Throttle Position Sensor?
- What symptoms will a bad TPS give you?
- AIR FUEL RATIO GAUGE
- 1/4 mile times
- Gears
- est. total cost for 99+ head swap??
- Can I still use my Optimizer w/ a chip?
- ? About Slicks
- which supercharger?
- Carb tuning..Is there a place.........
- Hard cold starting...possible causes?
- Racing Seats for Daily Driver? Yea or Nay?
- Programming New EEC-V
- Will a vac leak or a bad MAF cause a lean or rich condition?
- Need new plugs, which ones to get.
- Anyone using a procharger?
- loose steering
- interior lights out
- CArb Question
- Electrical Probs, PLEASE HELP!!
- WHERE IS MY RADIATOR LEAK??? PLEASE HELP!
- Custom Seats, and Removing the rear seat.
- Super Charger
- SSM Lift bars?
- Bassani X pipe
- Rims . . . size . . . . directional?
- Suspension Upgrade
- Brake Upgrade
- How do you check your O2 sensors?
- What you all think about this theory...
- Anyone that has done the Bullit Intake Swap please come in.
- What sensor will cause Pinging if it goes bad?
- This is very stupid, but will removing the....
- X-pipe design same thru 96-01?
- O2 sensors... Where to buy at a GOOD price?
- What should I do with the PCV valve?
- 5lug swap question
- smoking on start up....
- Resolution for cold idle problem in open loop mode...
- Nitrous Question
- Vortech on a 97 Cobra
- Does anyone know...
- 70 mm T-Body on stock 5.0?
- Trac Link
- Q's about fuel enrichment on a carb/nitrous setup
- Engine Guys
- What are E7 heads?
- What valve covers to clear Roller Rockers?
- Anyone ever had problems with a Nitrous Remote Bottle Opener?
- Fuel Related?
- Looking for Lightening 42lb injectors
- Timing Chain Deflection.
- Car Hauling ??? Advice
- What are some good mods for a 96 cobra?
- Need advice! Local shop for heads & work
- Anyone know anything about the T-45 P.O.S. tranny
- 88 GT Fuel lines
- Do these problems sound like O2 Sensor related ones?
- I need a PinOut diagram for a A3M1 MassAir Computer
- Stiffest spring for a 28T Trac-Lok?
- Wolfe Race Craft-Anyone use them before?
- Info every racer needs, how to get the ocatane you need
- Wheel Hop Help
- I need instructions for Speed Density to Mass Air Conversion
- External Fuel Pressure Gauge?
- steering racks
- Weird engine noise...
- Drivetrain sagging
- tranny problem
- 94GT hot starting problems
- Gauge help !!!! ???? !!!!
- weak cylinder
- Eibach Sportline What Shocks.........
- Need recommendation on front struts
- Opinions on Bassani Xpipe with Cats
- Oil return for Supercharger / Turbo
- performance increase with cobra intake and gt 40 irons
- To all of those with E-303 cams...
- Anybody know where to get injecters checked?
- Where should I mount my Aeromotive FPR?
- Need help finding a short!
- T-03 rebuild how hard ?
- C4 Bellhousing
- Chattering in Rearend......
- 331 or 347 stroker
- occaisional hesitation problem
- Question???
- Electronics Gurus Inside Please
- rear end is leaking fluid bad
- Which Intake??
- Is there a cheap way to get a manual rack set up on a 94 mustang?
- Who makes the best piston and where should I buy it?
- Superchips or DiabloSports Chip???
- ?????
- QUESTION:
- QUESTION #2:
- Bunch of stupid questions....
- Decisions, Decisions!!!!!
- Nos question?
- Does anyone make a single turbo kit???
- Best 190 lph fuel pump?
- How do I swap rear springs on a Fox?
- What all you gotta do to swap carriers?
- What company makes those kick ass-noncork-valve cover gaskets?
- Looking for heads
- Air bag steering column
- Turbos
- Need Ideas !!!
- Change timing chain?
- How's an 88 351W block???
- 351 FOLKS WHAT GEARS R U RUNNIN
- Autologic "switch" chip?
- What did the turbo 2000 GT Dyno???
- QUICK! Where to get pintle caps
- Exhaust install finished
- temp senser question
- compression for the street.
- how do you dyno a fwd car
- Turbo Questions
- 4V Head Work Poll
- V6 Stang to GT Suspension???
- Sometimes hard to shift between 1st & rev
- another decision
- Vortech crank pulley
- Gauge Install ??
- anyone done a 377 stroker swap ?
- RPM limit for SVO 351...
- FRPP 392 SB or build my own???
- True or False: TKO Tremec
- Why car won't shift right?
- Umbrella valve seals any good?
- 1996 to 1989 swap
- 4v motor swap in a 00 GT
- Low Coolant Light
- changing heater core?
- Roller Rockers
- tire sizes/speedo
- has anyone heard any thing about the ram air for 99-02 mustangs from ageclassic.com
- Interesting phonomeon, elsebody else experience this
- i got some kinda prob
- SC & Cold Air Intake Questions
- ?'s about SVO's
- GT-40 intake
- Car won' t Idle/ First Kill Story
- question about drag radials-BFG
- True or False: Lenghten driveshaft 5/8" for...
- with all the turbo intrest: cams for turbo's
- HELP! Crown Vic & MAF questions...
- Why do people want truck lower intakes?
- A T3, T4, or T4/T3?
- The heater in my car .........
- New DSS 306-Fuel and blower ?'s
- How does SPEED Density work?
- Speedo Question
- 3G alternator install: any hidden tricks I should know about?
- clunking noise...?
- My temperature adjustment won't go all the way to HOT???
- Starter Questions:
- Using Diesel as oil?
- 351 swap, new headers?
- How fast can my AOD be???
- What size is the stock MAF on a 93?
- Who makes a MAF bracket...
- 5.4L into Crown Vic
- Any aftermarket manufacturers of those bullitt style gas tank lids?
- 94 + Octane ?
- Installed a TRi-ax and i hear grinding????
- Thin headgaskets to raise compression?
- What should I do?
- What's involved in installing a torque converter?
- Sway Bar???
- WTF!? How much fuel does a NOS systems fuel pusher pump?
- Anyone had problems with their AOD's?
- Minimum amount of sensors to run a MAF 5.0???
- Cheap (homemade) intake systems?
- T-5 Bellhousing/Input shaft question
- Cobra brake fluid question
- Newer Brake Question...
- FYI wiring harness
- Trouble with my 3G alternator... what gives?
- Throttle Body recomendations?
- caster camber plates
- Do I have a bad voltage regulator?
- Tranny Help
- Have a question about u/d pullies
- TFS Trackheat intakes on a mild NA 5.0L
- check engine light prob
- Info on TT setups
- Good Torque Camshafts
- Systemax kits?
- 2 Easy Questions
- What shop would you let put a TKO in your 97 Cobra?
- 01GT Throw Out Bearing Problems???
- Who has rebuilt a T45?
- Longtube headers for Canfields
- Anybody ever tried a Throttle Enhancer Calibrator?
- Manual Tranny Fluid
- TrickFlowHeads
- 393 Intakes???
- 351M/400 be used for an EFI setup?
- thottle body question
- Paxton Sn93 Help, Anyone???
- Front spindle question..
- H-pipe removal???!!!
- Mass Air???
vBulletin® v3.8.1, Copyright ©2000-2009, Jelsoft Enterprises Ltd.